All Parker hose barb fitting pipe threads are made to Dryseal standards.
Connectors, unions, nuts and extended elbows and tees are
machined from CA 360 and CA 345 brass.
Temperature and Working Pressure Ranges
From -40° to +160°F. at 150 PSI maximum.
Note: These fittings are intended for use with 97HC hose clamp, similar
type clamp or a crimped ferrule.
1. Cut hose cleanly and squarely to length.
2. Slide clamp on hose.
3. Lubricate hose. Push hose on fitting until hose bottoms against stop
ring or hex.
4. Position hose clamp as shown below and secure with a screwdriver
or wrench. Maintain “A” dimension noted below for proper clamp